Home > Creative Solutions > Cycle Time Reduction >

Copper Hot Shots, Double Detents, 6mm, KC5423-MC
Copper Hot Shots, Double Detents, 6mm, KC5423-MC

Alternative Views:


Product Code: KC5423-MC


Snap Serts are a time-saving installation and release system for molded-in inserts. Manufactured in a detent ball construction, they simplify pre-molding installation with a simple push-to-install motion. Post molding is just as simple as the inserts easily slip off the holders during the normal de-molding action of the plastic part. Use of these devices eliminates the need to screw and unscrew the inserts onto a bolt.

Hot Shots take the Snap Sert concept two steps further by adding extra holding power with the double detent design and faster heat transfer via the copper alloy make-up intended to be used for difficult areas or complicated inserts.

Recommended uses: Inserts, deep cores, and hard to heat areas. Hot shots come with nut and washer.