Mounting Components

Home > Framing & Mounting Components > Mounting Components

Sort By:

Page of 4

Cotter Pin, Circular, KC6555

$0.15

Circular Cotter Pin used in the receiver set assembly (KC6589) along with the Clevis Pin (KC6567).

Clevis Pin (KC6567) and Bolt Receiver (KC6580) sold separately.
This is a hard drawn spring wire, Zinc Plated

Spring Shim, 0.010" - KC6650

$0.40

Spring Shims (Washers) 0.010".
Use between mold and frame to tighten fit.

Spring Shim, 0.020", KC6653

$0.40

Spring Shims (Washers) 0.020".
Use between mold and frame to tighten fit.

Spring Shim, 0.031" KC6656

$0.40

Spring Shims (Washers) 0.031".
Use between mold and frame to tighten fit.

Bolt Pad, KC6518

$0.90

Washer style pad for hardened steel bolts to prevent deformation of steel frames under the hex bolt heads.
1 1/4" diameter X 3/16" thick with 5/8" hole, punched and hardened.

Clevis Pin, KC6567

$0.95

Clevis pin for holding receivers in place. This clevis pin can be used with Norstar's Receiver KC6580, and KC6555 - Circular Cotter Pins to make up a Bolt Receiver Set - Part Number KC6589.

Clevis pin does not come with Circular Cotter Pin. Order Part Number KC6555.

Spring Shim, 0.058", KC6659

$1.38

Spring Shims (Washers) 0.058".
Use between mold and frame to tighten fit.

Spring, Bolt Compression, KC6540

$1.80

Spring used to assist bolts in disengaging from receivers when loosened.

Springs should be removed if mold is to experience excessive heat. i.e. Teflon™ Coating.

Bolt Spring is part of our Bolt Retraction Set, Norstar's Part Number KC6350.
Size is 3 1/2" X .855" o.d. X .675 I.D.

Washer, KC605080

$2.25

Galvanized Zinc washer for use with bolt and receiver assemblies.

5/8" I.D.

Collar, Teflon™ KC6590

$2.64

Teflon™ Collar used to keep spring attached to bolts when removed from recievers. Teflon™ Collar is part of Norstar's Bolt Retraction Set - Part Number KC6350.