Air Assisted Products

Home > Production Related Parts > Air Assisted Products

Sort By:

Page of 1

Pneumatic Air Ejector - KC6264

This product is for removing a plastic part that is difficult to grasp or pull out of a mold shell, such as a flat lid. The Pneumatic Ejector can be installed to push out the part from the mold cavity. By connecting to external compressed air (not form the machine arm) the spring loaded ejector pin is extended by 35mm, lifting the molded plastic part out of the shell. The wall thickness of the molded plastic parts, material, and demolding temperature influence the functionality. After separating the compressed air, the cylinder automatically retracts again.

Call for price.
Spacer needed with this product. Call for price.

Vortec Flow Gain Nozzle®, KC6748

$72.25

Model 1200SS - Vortec Flow Gain Nozzle
Using the same principle as the Transvector® this is very effective in smaller applications.

Air Aide (Air Amplifier) - KC6578

$172.00

Air Amplifiers, deliver a high volume of oven air to specific areas to assist in more efficient heating and cooling. This high-flow bladeless blower has no moving parts, so they are inherently safe. They amplify compressed air volumes.

Gas Transfer Assembly, KC6770

$185.90

Gas Transfer Assembly.

Often it is necessary to have an air line across the parting line. Our Gas Transfer Assembly eliminates the need to disconnect and re-connect your air lines. This Gas Transfer Assembly will do the work of connecting and disconnecting your air lines for you each time the mold is open or closed.

Price does not include stainless braided hose with 2 male fittings - 12'' length - $25.47.
Each additional inch - $.55.

Cool-Aide (Internal Air Cooling)

$795.00

Internal Air Cooler

This internal air cooler is a device that works on a standard compressed air supply and operates with the vortex principle. Compressed air enters the tube and is separated via a vortex into two parts, cold air exits on one end and hot air on the other. By hooking up the cold air end of the tube, cold air can be circulated inside a rotationally molded part to provide for more even cooling, inside and outside the part. These tubes are adjustable for airflow and consequently not only the amount of air entering the plastic part, but the temperature of the air also.

This small lightweight separator is made of stainless steel and has no moving parts. This is just the solution for those who want to reduce cooling cycle times and warpage due to uneven cooling in plastic parts.

One 3/4" smartvent is included. (KC401857)

The manual can be found here.