Machined Aluminum Caps

Home > Mold Components > Machined Aluminum Caps

Sort By:

Page of 1

Machined Aluminum Cap, 1-3/4" KC5007

$288.00

1 3/4" (thread diameter) aluminum cap insert with1" Block for drilled vent hole, for molded in threads.

Fits Kelch Assemblies Plastic Closure Series H45, 45 Gauge Utility 175, Contour 175 caps. Inserts are machined with calculated shrinkage of 0.025 inches per inch for polyethylene.

Cap inserts can be special ordered to accommodate the calculated shrinkage of other materials.

Aluminum Cap insert with machined modified buttress thread to fit a variety of tank diameters.

If a hole is needed please specify the hole size in the comments section upon checkout.

Special outer diameters on request. Also see Norstar's other aluminum caps on special. Part Numbers: KC5013, KC5016, KC5022.

Aluminum Cap, 3-1/2" Machined, KC5022

$310.00

3 1/2" (thread diameter) aluminum cap insert with 1 1/4" Block for vent hole, for molded in threads.

Fits Kelch Assemblies Plastic Closure Series H70, Target 350, TIPS 350 and Power Grip 350 caps. Inserts are machined with calculated shrinkage of 0.025 inches per inch for polyethylene.

Cap inserts can be special ordered to accommodate the calculated shrinkage of other materials.

Aluminum Cap insert with machined modified buttress thread to fit a variety of tank diameters. Special outer diameters on request.

If a hole is needed please specify the hole size in the comments section upon checkout.

Also see Norstar's other aluminum caps on special. Part Numbers: KC5007, KC5013, KC5016.

Machined Aluminum Cap, 2-1/2" KC5016

$312.00

2 1/2" (thread diameter) aluminum cap insert with1" Block for drilled vent hole, for molded in threads.

Fits Kelch Assemblies Plastic Closure Series 65, Utility 250 Caps.

Inserts are machined with calculated shrinkage of 0.025 inches per inch for polyethylene.

Cap inserts can be special ordered to accommodate the calculated shrinkage of other materials.

Aluminum Cap insert with machined modified buttress thread to fit a variety of tank diameters. Special outer diameters on request.

If a hole is needed please specify the hole size in the comments section upon checkout.

Also see Norstar's other aluminum caps on special. Part Numbers: KC5007, KC5016, KC5022.

Machined Aluminum Cap 2-1/4" , KC5013

$350.00

2 1/4" (thread diameter) aluminum cap insert with1" Block for vent hole, for molded in threads.

Fits Kelch Assemblies Plastic Closure Series 62, H60, H61, H63, Comfort Grip 225, Sure Grip 225, TIPS 225, Guardian 225, Venture 225, Contour 225 and Power Grip 225 caps.

Inserts are machined with calculated shrinkage of 0.025 inches per inch for polyethylene.

Cap inserts can be special ordered to accommodate the calculated shrinkage of other materials. Aluminum Cap insert with machined modified buttress thread to fit a variety of tank diameters.

Stock OD of this cap is 3", and special outer diameters are available upon request.

If a hole is needed please specify the hole size in the comments section upon checkout.

Also see Norstar's other aluminum caps on special. Part Numbers: KC5007, KC5016, KC5022.